Marble Restoration & Stone Care Service

Marble Shelf Installation

Installing a marble shelf on a kitchen backsplash requires careful planning and execution to ensure a secure and aesthetically pleasing result.

Steps of the Marble Shelf Installation:

1. Choose the Location:
   • Determine the desired location for the marble shelf on the backsplash. Consider factors such as height, accessibility, proportions, and overall aesthetics.
2. Mark Brackets Positions:
   • Apply masking tape to the backsplash and use a pencil to outline the bracket’s positions on the backsplash. Ensure the marks are straight and level.
3. Install Brackets:
   • Hold the brackets against the backsplash, aligning them with the marked outlines.
   • Use a pencil to mark the screw holes on the backsplash through the bracket’s holes.
   • Use a drill bit diameter the same as the screw anchors.
   • Secure the brackets to the backsplash using screws and a screwdriver (usually sold with brackets).
4. Test Fit the Marble Shelf:
   • Place the marble shelf on top of the installed brackets to ensure a proper fit. Make any necessary adjustments to the placement of the brackets if needed.
5. Secure the Marble Shelf:
   • Apply a small bead of silicone adhesive or caulk on the top of each bracket.
   • Carefully place the marble shelf on top of the brackets, pressing down firmly to ensure good adhesion.
   • Use masking tape to hold the shelf in place while the adhesive sets, if necessary.
6. Allow Adhesive to Cure:
   • Follow the manufacturer’s instructions for the adhesive to cure properly. This may take several hours or overnight.
7. Apply Caulk:
   • Once the adhesive has cured, use a caulk to apply along the edges of the marble shelf where it meets the backsplash. This will create a finished look and seal any gaps.
8. Final Check:
   • Double-check that the marble shelf is securely attached to the brackets, level, and properly sealed with caulk.

Submit Your Order or Ask a Question :

In Post Question: Email:  
Select Your Borough Manhattan NY Brooklyn NY Queens NY Bronx NY Staten Island NY Long Island NY Upstate NY New Jersey
Picture optional (up to 2MB):
File:

When to expect a response?
You'll get a response within a few minutes or hours and usually not longer than 24 hours.

Holes Drilling for Brackets Mounting/Shelf Installation Custom Insert into Counter Edge after Fabrication & Installation Countertop Custom Insert Fabrication & Installation Countertop Hole Drilled for Faucet Granite Countertop Faucet Hole Drilling Trimmed Counter Side For Refrigerator Niche Travertine Round Coffee Table Fabricated Clock Marble Base Cutting and Shaping Unnoticeable Seam on Double Edge. Green Serpentine Marble Clock Marble Base Ready to be Installed Travertine Table Outdoor Fabrication Botticino Marble Raw Piece Trimming Tarnished & Dull Rectangular Marble Polished Rectangular Piece. Botticino Marble Custom Molding Fabrication. Botticino Marble Green Serpentine Counter Double Edge before Revamping Edging on Green Serpentine Mini Countertop Counter Marked for Faucet Hole Drilling Window Niche Refit before Grinding Up to Allow Door Open Raw Cut Edge before Revamping on Serpentine Counter Window Niche Ground Up and Door Fitted to Open Counter Line Across Trimming Refrigerator Niche